Is there any reason why the hyperstrada can't have throttle spacers installed. It has heated grips and I've been told without an explanation that throttle spacers won't work on this bike, only on a hypermotard. Does anyone know why that might be? Is the throttle housing different? I can see that the cable for the heating element does run into the housing. Maybe time to get some security torx and open it up Cheers Jack
Good point. I've ordered some security torx so i can open it up and then get a spacer for it. Just wanted to see if anyone might know why it shouldn't fit.
Taken the throttle housing apart and see no reason why a spacer can't be put in there. However i would say the actual space available doesn't seem enough for the spacers available to buy. Maybe i can shave them down a bit if need be. Some pictures..
What type of spacer does it need, I have 3d print files for two kinds, one is a two piece arrangement, other is a 1 piece ,which fits my 2020 multistrada enduro Once im back in UK I dont mind printing them out and popping them in the post to you Regards Neil
Hi Neil, that would be great thank you! It's a one piece design. I'll pm you my address when you're back from travels?
I dont want or even expect payment, i belive in one good deed, leads to another, Topolino has been a massive help this week, only right I pass some help on
I agree with that, but I'm more than happy to cover postage and a few beer tokens for the effort, so please do
Honestly I dont want payment, the print filament is pennies, ive a stack of jiffy envelopes, postage will be couple of quid Buy me a diet Pepsi at WDW 2028..... Regards Neil
Throttle spacer added thanks to @Neil Byrne. Much appreciated, thank you. The throttle spacer required is not a full wrap around one as the space available is different. And perhaps that's why I've been told the spacers used on other ducati models don't fit, because they dont! However cutting one side of is all that's needed and now, slop be gone.
