No, left the factory as a BP but I have kept the original subframe and have the plastics still so can swap back 1 day if required.
It was the easiest and tidiest way I found to secure the monopost to stop it bouncing about and also to pull it closer to the subframe
To be fair it’s no more tricky than removing other bits just a craft knife to cut the long tie. I looked at other ways like fabricating something but I felt it was over complicating something that can’t be seen and does the job and is not affected by the heat from the exhaust.
All sorted. Thanks for the input and ideas gents. @Ducbird @El Toro Please close the thread before any unwanted and unwelcome comments are added
I doubled up this, 2 think, along the length of the subframe of the BP part that gets cut down and to the underside of the tail plastic. https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/253162194173 Impossible to see without a torch and on yer hands and knees. I do not consider it a "bodge" in any way. Ducati where happy enough to attach the tool kit with Velcro!
