I need to remove the bearings out of the cam end and also the brass insert in the clutch casing. What kind of tools do I need to complete this task? Trying to find something on Ebay Cheers roadkill
Something like this would do I would have thought, https://www.ebay.co.uk/itm/9Pcs-Inn...151388?hash=item48f17d139c:g:v70AAOSwQ5tfpR~T
Roadkill, I tried to remove a clutch casing bush on a 900SS a bit ago. It was an absolute pig. First question, does it need replacing. I ended up dremelling. I cut a groove in it as thin as I dare then caved it in. I will look for the post I did. Also the bearing. I made a tool, again I will look for the post and check it was for the same bearing, if not you could make a similar one. Cheers Gaz
Roadkill, Here is tool. Sorry wrong bearing. Just one thing on the bush. There is very little room to get the blind bearing puller in. Cheers Gaz
