Fired the bike up for the first time in a while today and as soon as the engine started it flashed this up. It's had slicks fitted to the oem wheels, and the Ducati race bodywork fitted since being started, it's also been into the dealer for a gps module install, i'm not sure if they fired it up or not. Also they did some recall things. I've taken the wheels out and checked the abs sensors etc and everything looks as it should, restarted it a few times (!) and still same error. Any ideas ? It's off to Portamio tomorrow ...................
did you have the dummy headlight fitted as well as the fairings.. if the air speed and pressure sensor isn't reconnected it can say that.... and you are not displaying air temp.. minimum call out fee applies! its a bitch to get to and needs the nose fairing sections off it sits at the back of the dummy headlamp bit sort of on the clutch lever side
if you are going to Portimao you also want to put it in track A mode and full power...... you can still have the display as a rev counter if you like. and suspension wise I would go to fixed front and rear best you can do is play around with the buttons as it is difficult to navigate and find stuff
Yep spot on, forgot to reconnect that - as soon as I did fired it up air temp displayed no traction error............Thank you so much, couldn't think straight and went into full panic mode as dropping the bike tomorrow ! I'm getting good at getting that front end on and off !
I've only ridden it 0.5 a mile up and down the road so far ! I was planning on putting it in B mode for the rear trail brake feature, how come you use A ? I haven't researched the difference yet in A or B ?
