Separate names with a comma.
Had to purchase a spare pump with the flange attached. Please close thread. Thank you.
Check CPS sensor is gapped correctly.
(Please move thread if incorrect place) Hi guys, I am desperatley after this part for my bike (08 1098), as the tank was dropped the inlet and...
For reference, my bikes gap on the feeler gauge sensor waa 0.05mm.. far too close.
Check CPS sensor, as the bike heats up it expands and turned out my sensor was literally touching the teeth when warm and suddenly shutting off...
Hi all, I have for sale a genuine 1098 red front nose fairing. Was involved in a 30mph lowside however in very good nick bar one or two scuffs /...
Hi all, Looking for a 1098 gear pedal UK based as everything else seems to be from China. Kind regards, Dan
Hi all, Recently purchased a full set of fairings. My old tail end was a carbon race single seat so didnt require a lock etc. Therefore I am in...
Ecu / Reg bolts through one of them
Ground wire on ecu, have you removed by any chance? Did this last time same issues, put it back on then fired up straight away.
Thx Joe. Pm
Hi all, Recent low side unfortunately. Trying to get hold of either like for like fairings or replicas if fitment is good. If anyone has anything...
Hi all, (. https://www.gumtree.com/p/replacement-parts/ducati-1098-engine-vert-cylinder-con-rod-gone/1388210512) Posted a while back just got...
Glad to hear it pal
Check your bike has has the heat shield recall done for the regulator / battery if you're planning on running oem regulator again too.
Bit late but have you checked the actual calipers pistons are functioning correctly and not sticking?
Thanks for reply Ricky. Some reason I thought it was connected to this 'fume cannister' as shown at 0.43 onwards?here [MEDIA] - not something I...
*Pipe is number 19 on diagram* Hi All, Apologies if this seems like a daft question, bikes almost put back together but I can't for the life of...
Appreciate the feedback mate. Yes believe it is slightly out of alignment hence keep adjusting. Will have another pop this week if not will cut....
I know it can be hammered right back into the engine housing to where the nut attaches, it moves freely with light taps all the way up to the end
