Separate names with a comma.
Each to their own but I've never liked the thought of a diy paint job on casings, probably because I don't trust myself to do a good job. Cheers Gaz
Yes, going to treat with ACF50 Cheers Gaz
At the moment I can't think of many better sights than that. [ATTACH] Cheers Gaz
Hejira858, You seem to have quoted a post but can't see a reply. Anyway, I got some adaptor and extension from machine mart where both male and...
First any comments welcome especially about 3 bond on cylinder/head joint. Second run into problem with torque tool. Using adaptor from 3/8 to 1/2...
Trying to assemble cylinders and heads on weekend. Torque 3 stage 15, 30, 39 Nm (Haynes) for new type studs which I have replaces the old brittle...
No probs, I would have come back to it - no o ring did not make any sense. Cheers Gaz
Many thanks for replies. Thanks for offer of casings but would like to stay with unpainted. Cheers Gaz
Anyone know what engine casings are interchangeable on the air cooled 900ss. Basically just wanted some spares if anything happened to the 1992...
Regarding o ring in rear caliper. Having looked again (and I know the diagram does not show it) I have found an o ring in another box of rear...
It was just a demo yes I will put the base shim/gasket in. Cheers Gaz
Piston ring compression tool - sorry jubilee clip and some plastic pipe. I prefer putting the piston on con rod first as it's easier to get the...
Hope it's OK posting here rather than new thread. Just been watching a "Brad the bike boy" video (in my tea break) and found an o-ring I did not...
Had problem uploading file so did the YouTube thing. I know there is probably a bit of drag with the con rods resting on casing. Hope I have done...
By the way Iam not saying this is the correct preload. I am just showing what I've done and the decision I have come to. I wanted to post so...
Thanks for replies chaps. Been finishing off today. Lapped a couple of thick shims down as I thought 0.1 was too much of a jump. Selector Drum 0.9...
I am just shimming at the moment. What's your thoughts: Selector Drum - 0.8 end float - may be a bit tight but happy with this. Clutch Input -...
Another apology. It looks like there was only one sleeve or spacer as it is called. Having looked at the parts list the quantity was only 1. So...
Chuee, At the same point as you (with same bike) I got these from youtube - Andy motorcycle obsession and some other reading. This is what I am...
Apologies, I thought the eagle eyed of you would have noticed my deliberate mistake. I think the ring I pictured was from my old Beetle, it was no...
