Separate names with a comma.
There are 2 APS voltage readings, as Paul mentions. One will be either half the voltage of the other, or they will read inversely as you open the...
Have you read for any errors or seen any warnings on the dash? The 821 and 1200 can go into limp status if there’s a problem with the APS, the...
You'll pay import duty and VAT @ 20%, plus a handling fee. Make sure you're not charged the Italian VAT though. Some are still "trying it on" with...
Usually, if the indication begins to drift again after a reset, it’s a sign the sensor is on its way out. Again, sometimes the calibration...
230nm is for the single sided wheels. Yours is 180nm
Rich is a good guy. He’ll be able to help. Tbh, for what they fetch secondhand, youd probably be better getting another one and build your parts...
I can’t remember for sure, but I think it was an age/year thing. Possibly when the size of the exhaust valve cover changed? I’ve got a 996 head...
Not off hand, but most fasteners tend to follow DIN or BS standards. A low profile cap head, will be the same. I don’t think the ones Brembo used...
Have a look on the Accu fasteners site. Top quality, certification on some fasteners etc. A proper engineering supplies business. They’re one of...
From your description, it sounds like it’s not stood well. Perished rubber, corroded fittings etc. usually points to damp.. From experience, even...
The V4 motors run the pins at 90 degrees iirc. As northern monkey says, it’s about power delivery and allowing tyre grip to recover. I can’t...
It’s for routing the brake line and sensor cables. Keeps them in place once secured
Yes, you need to remove them. Airbox and throttles come out as one piece. Disconnect cables at throttle, jubilee clips on each inlet rubber and a...
They're in there to help allow the brake carrier to rotate when the chain is adjusted. Kind of a crude bearing if you like and a seal all in one...
It is a tight fit. Watch for the last shim dropping into the circlip groove. That’s the ball ache. Plenty of grease on the o rings to hold the...
Check the rear brake micro switch. Had a few that have dislodged themselves leaving the rear brake light on. That will disable the CC. The switch...
I use Cohline 2190. It's widely available. Usually available by the metre. It's E10 suitable and importantly submersible, which is the one to...
There's no screws on the switch gear as such. It slides on the bar and is held in place by a small plastic clip that it locates on to. You may be...
I find Skyrich ok but the Shido on my 899 is over 6 years old now, rarely on a charger and the bike has never failed to start, even after a very...
Sounds like a split pipe as already mentioned. The spraying fuel in the tank is usually the give away. Worth checking the fuel pressure, that...
