Separate names with a comma.
It wasn’t a 7mm, that’s for sure. Can’t remember whether it was a 6 or 8 though
Removing the intermediate section is easier if you pull the rear header with it still connected. Just remove the spring from the manifold above...
If you’re not sure with twisting the caliper, pull the pads out. That’ll give you loads of wiggle room
Used Translogic several times without any issues. Improved feel and virtually the same money as OEM.
In the scenario that the OP mentioned, I'm probably not as "independent" as would be needed either? ;)
As a rule of thumb, you should never cut and/or solder into either of the can bus cables. The voltages are low and super sensitive to the signal...
There was a recall on some of the Hypers to install a diode into the wiring to protect the CAN. I've seen a few knock out the dash and ECU. It...
Monster or super sport 750/900 or ST2. They have adjustable TPS so won’t be off anything that has a software tps reset. They’ll need doing the old...
Not aware of anything happening with Monster, but there's a couple more new bike "premieres" to come yet. One today and then another maybe next...
You’re in spec on all gaps for checking. The measurements you list as “operation” are the assembly figures. The 2 closers you have at 0.2 ish, I’d...
It’s a clips that retains the exhaust valve cable. Mounts over the cable end on the servo motor
The manuals were a little misleading. The figures never correlated and unless the motor was out of the frame, you couldn’t use the deflection...
The glycol, as mentioned, is outdated now. Go with an OAT spec. It’s got a longer service life of 4 years and is much finder to the alloys etc. in...
Try autotrader for a few ideas. £15k max, a few filters and have a look.... Usual hot hatches, M235/M240's, Caymans, XKR's, even a couple of...
5 and 6mm Allen key trick is more reliable ;)
Honestly Sev, I don't recall. I've always done the tensioning on the different engines with the specific tools. Still have the spring balance for...
The 'stretta motors were the first to use the Hz tensioning method. There was no figures for using that tool. Iirc, I don't think it fits in...
Bloo has Pistals in him. Used them several times over the years. When I did my own 853 big bore kits, JE supplied the pistons to my spec. I’d...
120 HP, good torque spread and light weight should make for some decent, capable road bikes ;)
I agree. There’s something about the DVT motors that saw the oil consumption rise. I’ve not come up with any reason as to why and there’s not been...
