Separate names with a comma.
Try taking both out and swap them over? They might have been taken out, not sure why, and not put back in their original bar…
That sidestand looks like an old "suicide" type. The switch was just to light up the light on the dash. The switch you have is the later type...
ZDM748S*xxxxxx* Is the VIN, including the *’s. The older bikes didn’t have 17. Maybe a more recent standard? I don’t know.
Is the speedo working ok? If so, and it’s a sensor issue, then it’ll be the front one. As mentioned, they can rub the cable if it’s not routed...
Yes, that's the original sender... Must be one of the last in existence LOL It'll need the firmware update to work with the later senders. Update...
From 2013, the fuel sender used and subsequent updates needed a firmware update to the dash and BBS control units. I'd guess, your bike already...
You know the OEM ones are braided already?
I had a customer the other day on a new Scrambler with the matte red paintwork. Looked mint and got chatting. He's got his own detailing business...
Or the Ti nut was simply not machined well enough? It's sometimes "perceived" that because it's Ti or some other fancy aftermarket product it's...
I don't really see any reason not to use aluminium if I'm honest. I wouldn't spend my money on Ti replacements other than for aesthetics or "blinf...
Another reason the nut cracks is the over tightening of the axle pinch bolts. On the older bikes, that even could oval the axle itself and make it...
It's awkward, but with a bit of lube on the job, try and twist the cap also before pulling on it too hard. When you refit, use a smear of silicon...
There was a possible issue with the ecu getting spiked by the coils. There was a tech update to install a filter in to the wiring to protect the...
I’d guess it’ll be about 300ml, maybe 400 at a push…… just a hunch ;)
MTS and Streetfighter drain to sump pretty quick. Only Panigale needs a few hours. If that's after 16hrs, it needs toping up for sure.
We have a loan bike now Dibble ;) have done for the last few years as it’s a requirement now. Last year we couldn’t get one, and this years took...
Would appear so. That's going to be down to the grind. Not much can be done about that...
"1mm lift without clearance" is just that. No clearance. The easiest way is to slide a feeler gauge in there rather than trying to account for it....
Are you taking the valve clearances into account? If you measure at 1mm valve lift, but with a 0.15mm clearance, you're effectively measuring...
Sorry. I hadn't picked that bit up..... I have no idea why they'd do that?????
