Separate names with a comma.
Before you refit the carrier assembly, take a small cold chisel or a dot punch and punch the back edge of the sprocket, around each cush drive, in...
You don’t need a centre stand. Put it on the side stand and strap the front brake lever for a bit of security. Slacken the chain as much as...
Check the cable around where it runs under the mudguard. It’s quite common that after work on the front that it gets disturbed and ends up rubbing...
GL with the sale Paul. Will make someone a great bike! This bike is one of the most genuine and well kept 996 I have seen. I looked after it...
The tool is a flat blade with a slight crank in it to help with access.
The switchgear isn’t designed to split. It’s captive on the bars, held by a clip that needs a tool to release the switchgear. If the connector is...
Basically, yes. :)
There is a spacer in there too, between the two bearings. It has to be snug to stop the inner races getting squeezed when the axle is done up.
The pump, coils and injector all get their 12v feed from the ignition relay, all the same circuit. I’d check for that 12v feed first.
Pretty much an industry standard now with cars as well as bikes. Systems are run over CANBUS and rather than cables from front to back for every...
Possibly the new ones drew too much current and have damaged the BBS circuit
There’s no relay or fuse. The rear indicators are run directly off the BBS ecu under the seat. It’s worth checking the polarity of the aftermarket...
Couple of thoughts.. Are you checking tension after you’ve torqued the axle nut? As the nut is tightened down, the swingarm compresses very...
The important bit is viscosity; 15w/50 is the best choice. I use Motul oils. There's no doubting 300V is a great oil but as mentioned, it's a...
And a 1995 TZR250SPR. This one’s 100% original but in need of a full resto, especially the motor.[ATTACH]
1991 NSR250 SP “Pentax”.[ATTACH]
The longer rod supplied in the kit is needed for 3 or 4 of the footpeg positions. Road or race shift. The stock rod is used for OEM position and...
Firstly, your lambda and MAP sensors are two different components. MAP sensors can fail in two ways and only one will bring on the eml. The only...
I can vouch for the bike. PM me if you want. I honestly don't think you'd find much better. Dom looks after his bikes extremely well. Some of the...
Did you get the sensors the right way around? The positioning of the sensors isn't relative to the cylinder they serve. As you look at them, the...
