Separate names with a comma.
You don’t need a Ducati part as such… M6 x 20mm or 25mm iirc. I use stainless cap heads on customer bikes with a bit anti seize. 9nm torque
Depends which forks you have as to which way the screws fit. If the screws go in from the top, removing the front wheel speed sensor helps getting...
Looks great now the decals are gone. The seat unit looks well to, especially with the black pads in place :) Give the front brake a bleed at the...
To cover the range you're talking of, you'll ideally need 3. 1/4" will take you to about 20Nm, 3/8" to around 50 Nm and the 1/2" will cover the...
Try a quick bleed of the master cylinder. Remove the reservoir cap and you'll see the bleed valve. It's a 6mm hex screw head. Undo it, pull the...
Yep. If it's been fitted well, or correctly, then it should be spliced into the loom somewhere. Just make sure if you cut it out the cables are...
That’s an old BikeTrac connector.
That isn't an official Ducati procedure, It's copied from "Brad the Bike Boys" website. It's very useful for getting the TPS setting back to the...
Does anyone have a fuel tank for a 916? I'm after a Red one, in as good a condition as possible for a '94 bike we're recommissioning. Old style...
749/999 is a diagnostic SW reset. Period. It's a fixed TPS with no adjustemnt. Any adjustment to the throttle stop or balance bar will bugger the...
Don't get too carried away with where the gauge needles sit. All you need are steady needles.
Great news... It's always good to start with the basics and not to get carried away with how complicated these bikes are. They're still joined up...
What gauges are they? Most need to have dampers in the pipes?
Yes. On the 749, the balance is mechanically set. Air bleed screws are used to balance and also control idle speed. Richen (screw in) them up to...
Check resistance between the individual cables… basically checking for a short
I’d pin out each wire from one end of the loom to the other, connector at a time. Do the sub loom in the picture, but also the connector back to...
Are the fronts working ok? If so, that probably discounts a dash issue. That’s the driver for the fronts and the receiver for the switch signal....
The new red connector is for Euro 5 compliance. You’ll most likely going to need a trip to the dealer tbh.
SOLD
Careful with the the southern references Chris….. I’ll get deported if the locals up here think I’ve defected :p
