Separate names with a comma.
SPIKE, no not checked the compression, but that is because I'm not getting a spark so thinking more electrical than mechanical. Lucaz, Yea, pretty...
Yes Mr Hodgson seem to like the Panigale, he also seems to have found a solution to the front end problems that Rossi and co are having with the...
Yes sometimes the answers are obvious :redface: Mine doesn't look like that one though.
Thanks for your advice folks, I may be getting in a bit too deep for my knowledge now, but when I get chance I will try and follow the suggestions...
I don't know if you can download the maps direct to your phone before going but if not watch out for Data roaming charges if you go with this...
My ST4S is only running on the vertical cylinder. I am not getting a spark on the horizontal cylinder. So far I have checked the horizontal plug...
I was thinking along those lines myself, but was thinking of just swapping over the LT leads to see if the problem switches to the other cylinder....
I am not getting a spark from the horizontal cylinder of my ST4S, I checked the plug in the plug cap of the vertical cylinder and got a spark so...
£130K for what looks like a baffle! :biggrin:
Phone them they are realy helpfull
Sixteen Grand for a bike with a scooter exhaust! :biggrin:
I have posted this elsewhere but thought it would be more use here! [ATTACH] Sticky Please Rob!?
this may help: [ATTACH]
Agreed it could slow down bike development, but equal(ish) machines should give closer more exciting racing. Look at it another way, having such...
Well thanks for all the responses, as mentioned in my initial post my second attempt was with the original springs and collars, so I assume it is...
Well I have put back the OEM set up and it works fine, so I doubt it just needs bleeding?
Brian, I measured the face to bearing, there was a slight difference but it seemed negligible, can't remember the figures now I didn't wright it...
The pressure plate had a new bearing fitted before I installed it. If by lifter pin you mean the piece that fits into the bearing, then yes....
Yep, there is a dot on the billet pressure plate and it was lined up with the post with a line on it.
Hi folks, I have tried to fit an open clutch pressure plate and stainless springs from a Monster S4R on my 1098. All went well untill I tried to...
