Separate names with a comma.
Looks like we are all similar. I had to swap the polarity as well Anth. Interesting on the swapping of the rear indicators to standard doing...
With mine the flash rate is high when the ignition is on and the engine not running. With the engine running the flash rate is normal. :rolleyes:...
JB thanks for reporting back to let us know. I was pretty sure it would make no difference using a 3 phase rectifier, but I was not 100% certain...
Looking blingtastic Nelson Just a question was it 5 wires? 2 for the indicators 1 for the tail light 1 for the stop light 1 for the common Just...
I like "If ridden well report stolen" John
Hi John I reckon the main draw is the immobilizer, with some from the ECU to keep the clock memory. The regulator/rectifiers can leak current...
Hyabusa Let me google that for you :wink: Only thing is you don't have the legal indicator spacing, this shouldn't fail an MOT but if the tester...
Oh India that sounds nice and sunny and warm. I miss when I used to travel to places like that. Anyway I wandered down to the shed with the...
Sorry John never measured it. I would imagine its in the milliamp range as when I connect up the charger its less than 30 minutes before the...
Hi John No problem. With the immobilizer and the ECU still needing some power there is a small battery drain. I have a set of flying leads on the...
I don't know the connector but a lot like that are like relay spade terminals that have a tongue on the spade and a ramp/wedge on the block. If...
Are we talking a digital dash and the red change up lights. One on the end flashes to indicate that immobilizer is active. It goes off entirely...
Nelson On the 999 forward not sure of earlier, there is no flasher relay, it's controlled through the electronics on the dash. On an older...
Not cheap Not cheap at all but Kellerman are nice products. I have the Micro 1000 but then they did not have the Rhombus version then. If doing it...
I didn't say horse them up in my reply. Mine are nipped up but I didn't use a torque wrench. All I'm saying is if they were backed out a bit then...
I could be wrong it has been known :rolleyes: I remember getting SS springs to replace the std set on my 1098 and when they were fitted the...
No bother Nelson I can't find the reference I had before. I found a VOSA manual for single vehicle approval it states 180mm. Scary thing in there...
Can't say it won't pass it all depends on how close your relationship is with the MOT tester. My tester is brilliant, uses common sense and does...
I always loved the look of hub center steering set ups. I remember reading a lot about them in the 70s and 80s. I thought the big advantage of...
I'm not 100% sure but I think the flashing stoplight is "by the rules" not permissible. Also indicators need to be a set distance apart, I can't...
