Separate names with a comma.
I've got one of these that's no use to me that you can have. :upyeah:
Which is what's happened over here...
748 will have 45mm exhaust system, you can get 50mm or bigger, either full system or one that has a 45-50mm increase in the mid-section but it...
Have you checked the main relay, the yellow one near to the battery - if it dies all the power goes off.
In days past Mercedes racing cars were silver because they just polished the aluminium body to save adding the weight of paint...
Thanks, I was hoping 0.9 would be good, the 1mm was probably erring on the cautious side. Big valve cutout to intake :upyeah: clips are a swine...
So been test assembling the engine today; M900 with 944cc JE high-comp pistons. After setting the piston ring end gaps to JE spec, I fitted the...
I had a slight leak at one of the joints on my 916 and used 'gun gum' which sealed it nicely, only downside was that is was a bastid to get the...
It's simple enough, basically unless they're prepared to show a low value and/or 'gift' on the packaging then you will get charged duty, a...
That said, you probably should be getting the crank balanced due to the different piston weights?...
In my Monster build I bought an ST2 engine (cam donor), the bottom end is basically the same as my M900 and 916, the ST2 being a 'hybrid' having...
Not done it because I swapped mine for an Ohlins yoke that is already drilled however after looking at the original yoke I see no reason why you...
I voted option 2 but my current Monster project has got somewhat out of hand and so would probably fall into category 1. Still have some way to...
Gibson Robot; Gibson Guitar: The Robot SG Guitar With Automatic Electric Guitar Tuning, Limited Edition Guitar Info and Pictures
Still got the blades? Only they look better than the ones in my knife... :biggrin: Back on topic; my Son had 2 punctures just a few days...
Never used stabiliser, have used the 'winter' fuel without any problem but if, as is usual, I'm servicing/setting the bike up then I'll drain it...
I think the 5w might be a K-tech thing, I've had their piston kits fitted in 2 sets of forks and both times they've used 5w oil, maybe it's better...
Threebond will have to do then, just seems odd that there's no 'O' ring on the front, yet the rear cylinder has an 'O' ring? The feed hole to the...
But I still need oil to flow to the cylinder, just not to the head.
Between the head/barrel is a hollow dowel/nozzle with an 'O' ring around it to seal between the head/barrel, although I have plugged this hole...
