Separate names with a comma.
In terms of servicing the only difference between the 2V DS engine and the 4V ST4/ST4s is the cost of the belts - about £20 more for the 4V. I...
The chain and sprockets on my recently purchased MTS were replaced at the 15,000 mile service. From experience with my previous bikes, chains...
Me too but I didn't find it easy to take the cable off. I found that by removing the bottom subframe fixing bolts and loosening the top ones I...
If they are the same as the ones on my ST4s and previous 900ss then they are 32mm, any deep socket should do. Just remember to loosen the pinch...
I think what was supplied as DP items depended on what was available at the time so there could be a few variations. DP exhausts are usually...
I have a set of OEM cans in the attic although I haven't gone up to look at them I'm fairly confident that what you have is not the original...
No, the 1098 forks have radial brakes.
The ?? one with the cutaway is the same as the one on my ST4s, also fits my 907. It should also fit any of the 3-phase cases from the early 2000s....
I have found 7 different part numbers; 701.4.001.1A : Paso 906. 907ie, Carb 900SS, M900, 916, 748 etc. Basically all the single phase alternator...
30mm
Yes, I used to do that too.
Sorry John, I was thinking of AndyW who has some connection with it.
Fuel lights are notoriously inaccurate. Zero the trip every time you fill up. Then the next time you fill up you will know how much fuel you have...
Any news on the 'DUC-911' software? Is it likely to happen soon?
I've been using an M* bolt with a locknut for years but this Christmas I got a Laser engine turning tool as a present. :smile: It has the...
I haven't got a photo but as far as I can tell the later master cylinder has the hose barb to the reservoir at about 45 deg to the cylinder where...
Finally got mine fitted today after leaving the washers off the inboard screws. They look good on the bike but it could be a good few weeks before...
Thanks Bob.
I spent about 90 minutes at them today and got nowhere. Like you I can't get the inner screws to line up. I can get the screws to thread without...
I doubt if it's the sensor or the engine would be running too rich. If you connect a switch to pin 85 of the relay ( the grey/black wire) to...
