Separate names with a comma.
Imola, The cylinder is in the loft but corresponding female housing in the crank case is nominally 100 (measured 100.1), from a 92 900ss so ties...
Imola, Found 1st list below on Sudco Site but main jet o ring does not seem to be on and there are a few number I have not seen before. 2nd list...
22-11-12, 16:37 Your theory is flawed - 23-11-12, 16:13 here's what they should look like.............. 07-12-12, 11:24 No...
Simon, that sounds suuuuperb - top effort. Cheers Gaz
Who me sir, not me sir. The trouble with me is I suffer from analysis paralysis. The lad had a aluminium tank, I read something about paint...
That's what I like about this forum - the members have a wealth of knowledge. They carefully consider the problem in hand using all the available...
A bit of surfing reveals that using a particular type of paint stripper (and I am not sure which) could corrode the aluminium. I have come across...
Aluminium casings - Stainless bolts - Copper washers - galvanic corrosion. Been mulling this over for a while, it's a lonely existence. In theory...
I think I rang K-teck & Showa and they did not come up with anything for mine either - so I stripped measured and got the part number off it and...
Sorry just realised yours is an IE and you probably have not removed it to get the size or code.
I did this a bit ago, check this post: 900ss (Showa GD022) rear shock stuff Ended up getting the bearings from local supplier "ERICKS" Cheers Gaz.
Cheers for that. Gaz
A timely post. Just started putting the carbs back together on the weekend but had to stop as I missed an o ring. I was quite happy with what I...
I think its FEKED one K and they are on ebay. I think they have been on for a few months now but if you go to their web site its a bit cheaper....
Any danger of a quick overview of the tips and trick if it was a bit fiddly I plan to do mine, I knew the bearings were not that much. What did...
Superb. I once bought a secondhand fairing bracket off ebay - thought the wife did not know about it - did I get it when she found out. Sorry but...
I wonder what this guy found out. http://ducatiforum.co.uk/f4/squeaky-rear-shock-4693/?highlight=rear+shock Cheers Gaz.
Sorry bearing in end cap - SKF 6202 - RS1 / C3 (RS1 = seal on one side facing out when installed) Cheers Gaz
Removed bearing from end cap. As mentioned above applied some heat. Put in oven supported with bearing facing downwards hoping that when it got to...
Bearings out with a combination of pulling and a little tapping for the last bit. Can obviously confirm step on inside for bigger bearing. Would...
