Separate names with a comma.
AFAIK they're still available from Marchesini. In fact Demon Tweeks list them on their site...
One for sale on this very site; http://ducatiforum.co.uk/f20/fs-sargent-mono-seat-748-916-996-998-a-9664/#post142841 otherwise; Sargent Ducati...
Euro headlights... Euro spec lights are easily converted, you only need the small reflector from inside the dip beam unit - or a replacement...
I've also inadvertently done it, the Optimate will trip out and show a 'fault' but works fine again as soon as it's reset. Optimate won't help...
I have a Sargent seat, much more comfortable especially at the front where it is raised to stop you sliding into the tank. Only downsides are the...
Just don't lose the receipt. I bought a small 1/4" ratchet drive as it is a perfect fit for adjusting the TPS screws inside my airbox, a couple of...
Probably not a good idea to have a half-cover on a Panigale... :rolleyes:
Here's one, probably around the same price as a dealer? Worth buying genuine IMO as it will probably last the lifetime of your bike and you don't...
I used a couple of short lengths of fuel hose with a suitable ID on my Monster, slit lengthways to get the brake lines in... :upyeah:
Finally a bike;[IMG] started up for the first time today, need to sort out the rough running but getting close. :upyeah:
I have a 'traditional' (big ally) clutch holding tool but it can be tricky to use if you've only got 2 hands so I bought one of these cheap Laser...
Looks to be the same as a steel-swingarmed Monster? if so I've got a pair from an M600 but they're for 17mm spindle and yours maybe 25mm? That...
The factory tool is easier to use (and less likely to slip) than a standard puller, here's an aftermarket version of the factory piece; Ducati...
Is it a threaded hole or a threaded insert? If it's an insert then it should be easy enough to replace.
I've got a spare ignition lock & key as I ended up buying 2 locksets for my recent project, unfortunately it wasn't a 'proper' lockset as the...
My Sister had an Alsatian, scared of everyone it was. However it would sneak up behind me and nip my hand then run away - fookin 'orrible dog, I...
'Tis a sad thing to be sure and without knowing the full facts it appears (from the news) to be a case of too many uncontrolled & inappropriate...
Ok, I need to take a closer look then. Would be good to see a pic of your TPS/mounting plate setup if you could get one. :upyeah:
Basically looks the same although that part of the shaft sits close to (right behind) the frame rail so would need to see how thick the overall...
Sounds good, are yours a pair of 'racked' carbs? because looking at the throttle shaft setup on my single carbs it doesn't look too easy to fit...
