Separate names with a comma.
Couple of hundred tops should see it done with that mileage, and thats' treating it to 300V :upyeah:
Seized pistons are pretty rare. Is the motor seized?? Can you turn it over by hand, or put in gear and push it? Maybe with plugs out to make life...
Bagley......call me 01623 238944. I'm here for another hour or so else call tomorrow. I got your PM and have replied
You can run a 190/55 rear without messing the DTC up. You might need to knock it down a click......This opens up pretty much any tyre option you...
Not sure the recall will be on VOSA. As it wasn't safety related. There are many bulletins raised that don't make it on there. Could be affected....
Is it an early one? There was a tech bulletin issued up to a certain VIN that called for the starter motor and gears to be replaced. Might be...
Never heard of the oil tbh. It's cheap for a reason IMO. May as well go buy halfords own brand????? Stick with a well known brand. Motul, Shell,...
That's bout right for 'stretta belts. For some reason, they'll quite a bit more than most. £340 is about right for a belt service. The higher...
The Termis are a bit louder. There's more of a "bark" to the sound, the tone changes more than volume. There's a fair bit of weight saved as well....
Speedymoto do an under bodywork kit for the SS. Replaces the engine mount as per a "proper" set up but the pucks are a lower profile so they sit...
You won't have a problem with either of those. Up there with the best in the UK :upyeah:
Yep. If its just cosmetic improvement, fit a pressure plate and maybe some stainless springs and alloy caps. Job done and you'd save a good few...
Think the HPK stuff reverts back to 320mm. You lose the spacers from under the caliper mounts.
Not much more to add. It's a replacement ECU, plug and play. £250 inc. vat and should be available sometime May onwards..
Pretty much any slipper for the dry clutch bikes will fit your 749. 1098 uses a bigger centre nut, but some kits come with both sizes. watch the...
Yep. It's not Skyhook. It picks up info from CANBUS relating to speed, throttle position etc. and adjusts on that info. It also takes into account...
The evo tech stuff is very hard to better IMO. Well made, fits very well and whilst maybe not the cheapest, it's defo very good value for money....
Have you adjusted the chain lately? Reason being, when the hub clamps are loosened to adjust the chain tension, then water can and usually does...
Avanti do a nice one. I use it over the factory tool. About £15 iirc
The discs that Kwack used Matt, were more petal than wavey. The edges and shape were much less aggressive. Conventional discs use drillings to...
