Separate names with a comma.
From 748 to 998 it's certainly the same I am not sure about the others but I suspect it is and in some cases it will be silver and not gold.
Have you tried a KTM or direct Brembo delaer, it might be cheaper. I know the clip you mean I have seen a couple of those rot on early bikes so...
It's quite highly priced for a 748E which is the base model for that year and it looks completely stock apart from the quick change rear sprocket...
Do not use any paint stripper it could affect the lacquer\resin finish. Carbon needs very careful sanding and if you break through the lacquer it...
Received the same as above today, so everyone that's signed will get a copy shortly if not already.
Powder coat without a doubt, it is thicker and more hard wearing. Plenty of colour options with powdercoating nowadays including metallics and...
If it is metallic silver, which is what it looks like, it may be possible to undertake a local repair and then relacquer the whole tank. Many...
This may be of interest to some, advance tickets to the London Motorcycle Show for £16 each. You need to register with Amazon local to get the...
This might be of interest I have used them myself for certain types of storage. Shelving & Racking | Bernard's Bins
I use the Clarke heavy duty boltless shelving and that works very well for me.
I don't think he is a member but I know he deals with certain members on this forum on a personal basis.
If you have crazing on the panels then you may have problems anyway as the lacquer finish could be cracked and if it is then the only way to get...
Yes, I repaired a carbon\kevlar 998RS race seat doing just that and it was very badly damaged. It wasn't worth spending a lot of money on it but...
There are different types of impeller depending on whether it is single phase or 3 phase. The impeller also needs to be shimmed correctly. From...
With a carbonfibre patch and very carefully let it into the hole in the fairing. You use a special film to allow the patch to sit flush with the...
The vents are not needed at all and the one you have seen is probably modelled on or from an 998R. There are two shapes but both are ventless. I...
I have bought two bikes in the past that have stood over a year. If you are prepared to completely rebuild a bike then that tends to eliminate...
The engines are a very close fit in the frame, is the frame clean and has it been repainted? if so the paint might just a fraction too thick. If...
Just to add to my posts, my 748R engine which used the surface discharge plugs is stock but is in a 748S frame so I can only use stock small...
I would say 848 that makes the most sense, but I have two 748's and the character of them is what attracts me to continue to run them. But they...
