Separate names with a comma.
A friend of mine used to own Superdials before he sold the business to Lockwood Dials. He showed me a couple of times how to dismantle the front...
The original locknuts for the rod ends are only alloy and they can round off very easily. Make sure you give them a good soaking in penetrating...
I have to agree with some of the comments above, return to standard and sell off specialist parts. I think your asking price is a little...
If the crack is not too bad it is possible to use a product named Devcon which is designed for casing repair to machinery. I have repaired a...
Mine was £1400 of which £900 was parts. As above no parts replaced just for the sake of it, mine needed new main bearings and new big end...
I second that for Ducati John. I went up from London all the way to Leeds to get my engine done by him. The parts cost far more than the labour,...
I use Iridium plugs in my 998 set to a large gap, about 0.030"\0.032". I have never had a problem using this type of plug although some may...
It seems to depend on the rubber etc. if you have a sealed (O ring) chain. Depending on the rubber seals used some chains degrade quicker than...
Mines not much better from new. It does seem a little low at the back maybe. If the seal is new then it will take time to settle down. You may...
The front fittings for the pin are captive and do not leak. If they have never been out before you will find that they have been locked with...
Other than the comments above you could check to see if the front tank mounting pin is sitting and bolted correctly to the tank and also that it...
If the slave does not bleed properly take it off and bleed it "uphill" by holding it in a higher mounting position. Sometimes on the odd occasion...
My local Aldi is literally round the corner from me so I will be having a quick look on Thursday. A few interesting bits and pieces of kit...
The 998 has a different ECU setup and does not use a chip, you would need to get the ECU map put on by someone who has the facilities ideally,...
This make work but you would need to be very careful about using it and not overfill. You do really don't want any material that is harder to...
As above, if the scratch is not too deep then it is possible and ideally you need to use a buffing machine as it's going to be likely to be...
I've had similar problems with my 998, which is also a Testastretta engine. Mine was the air gap on the pickup sensor. On the road it always...
I have a 748R engined 748S and also a stock 998. Everyone will have their own opinion of these two models, which are actually quite different to...
According to Rolling Stone Magazine it was John Bonham followed by Keith Moon. John Bonham | 100 Greatest Drummers of All Time | Rolling Stone...
Looks like it is £16.50 for the paint and £11.50 for matt lacquer. That's for a 400 ml aerosol. RS Motorbike Paint Online Store
