Separate names with a comma.
The following are the Ducati specified torque settings for an MY02 748 Tolerance ±10% unless marked (•) (•) tolerance must be: ± 5% Nm. ENGINE...
Absolutely agree, a small technical section with manuals, torque settings, alternative parts would be useful for reference
Looking for a structurally solid drivers seat, no concern if it is scuffed or torn (for a recover), anyone have one they would like to sell?
Samurai, I just did as suggested and the search function is entirely useless, perhaps that is why. Try it yourself and see what you get For the...
Graham the fuel pump relay is under the seat, the other one is for the ecu.
Ricardo, the main 40A fuse is located just to the right and below the battery near the starter solenoid, it is a big fuse. Is the small fuse on a...
Get the frame and engine numbers to Ducati and they will confirm, note my edit "one of 20 MY00 Red UK spec Mono Ss" is still quite rare and there...
Had similar on my 748 when the rubber boot on the pressure sensor had perished/split and let water into the sensor plug contacts (this is the...
Carlo, if there is no swarf, your adjuster should be ok. Looks like you may need new cush drives, some play is normal. I think there is a...
Daren, if you are you looking for the horizontal cylinder decat pipe http://www.mivv.com/en/products/ud-007-c1-ducati-999-2003-2006/
Looks like an unmolested MY00 S, quite a rare beast if it checks out. Basically that model year is a MY00 748R chassis with 748E motor. Spark...
Kozak, where to start? First question are you fitting a battery you bought in 2010? If so have you just filled it? If it has been sat filled...
Carlo, here are all the frame torque settings. If you need engine settings I'll post them up later Not sure you will get the torque settings for...
Carlo there is a small peg just forward of the drive cable on the top of the plastic enclosure, this abuts the lower mudguard mounting strap.
748 Torque Settings FRONT FORK Steering head retaining screw M8x1.25 23 ( • ) GREASE B Bottom yoke screw M8x1.25 14 ( • ) GREASE B sequence...
Carlo, the swing arm eccentric clamp bolts are M12x1.25mm, you will need to measure the bolt shaft length for the actual length. When you tighten...
Carlo, you have non standard screen bolts which extend far deeper than the original ones (which are brass captive screws of similar but much...
You used to be able to get a MY specific aftermarket loom insert which goes between the side stand switch and its loom connector to allow you to...
Downtown Slough? Herras fencing, lots of wheelie bins and Greek revival porches. Watch out for the man with a brush - he's out to get you or you...
Carlo, the spare wire is probably a feed for an alarm/immob tell tail led, if your bike was fitted with a Meta alarm system that is what it...
