Separate names with a comma.
If you have had a bit if a backfire, check that the manifold hasn't popped off the intake rubber
Use a dremel type grinder and grind the bush longitudinally until you are nearly through to the crankshaft. You should be able to split it and it...
[ATTACH]
As long as you can get the correct clamping force without overstressing the fasteners you will be fine.
Yes, I could have had a Desmo for less than I have spent on my SPS :sob::sob:
I hadnt ridden an electronic bike before, or after for that matter. I was surprised however how quickly you could adapt to letting the electronics...
A couple of years ago I hired a 1000RR at Almeria which was my first time with any sort of electronics. Within a couple of laps I found you could...
15-20 minutes at around 100C usually works fine. Unless the cases are very clean, be prepared to have a nice smell of hot oil in your oven......
Might be interested, any photos?
[ATTACH] Fitted traction control to my 996
Fitted traction control to my 996 [ATTACH]
I do, running 11.7:1
Ive got Pistal in mine,done by Lougi Moto, and I reckon that as they are doing the whole engine, it will be fine on the road. I have probably gone...
I found it surprising how long the oil temp takes to catch up with the water temperature. Shows how long it takes to properly warm up
It shows about 5 bar at start, dropping to 2-3 when hot, but I believe that the pressure sender is not calibrated for an RS dash. Gives an...
Been thinking about mine, and checked it today. Oil temperature reads ambient when the engine is cold, but the water temperature doesn't go below...
Now that was interesting!!!
Yes, with Adblocker its OK (still not as good as it used to be), on my mobile its sh*t.
Thats a nice solution that I bet didnt cost RS prices!!
