Separate names with a comma.
A washer with a slot in it. Pull down the preload spacer and slide the washer in to keep the spring compressed while you loosen the lock nut....
Nothing difficult about them @finm. I did a set a few weeks ago. 7.5 sae oil but I can't remember the level to set them to. I'm in the Outer...
Sorry. I don't know if the MP06 coils need resistors. With regard to the polarity, if you have it the wrong way round the spark will jump from the...
This one should fit but you may have to swap over the drive pinion as the ratio changed around 2010....
Not a service I've seen offered. I recently fitted a new starter from Electrex to my 907ie for £99 delivered. At that price I doubt if...
You are quite correct Chris. I hadn't noticed the bit about welding a nut on the back for the stand bolt to screw into.
If you can establish that the forward hole is definitely not leaking then a shadow plate will be your best option but from 10mm or 13mm alloy...
I'm sure we will all agree though that grey is the slowest! ;)
I have an old Eezibleed that I used to use for everything and it was brilliant. Now that you have mentioned it I really should buy a spare m/c cap...
Agree Agree, belts off when adjusting shims.
You must always have cylinder you are working on at TDC then there is no chance of a valve falling in. The valves will fall down until they touch...
Sorry, I'm on holiday in Turkey with limited internet and no access to my wiring diagrams and tech library. I doubt if it is the switch but would...
Yes, the resistance sounds ok.
Nearly all the Japanese bikes of the 70s and early 80s exhibited that trait. It was related to the steering geometry, I can't remember the details...
Yes. Also check that the tyre is fitted square to the rim.
It's something to do with the suspension geometry is set up.
If I remember right, resistance is around 750 to 950 ohms. Ditch it if it shows any signs of swelling. Substitution is the only real check.
Please give him my regards the next time you see him.
I'm certainly going to miss the service we had previously. H would do an exchange for me as long as the workshop had them in stock, if not they...
Yes, the warehouse shift seems to have been going on for a while. Bit worrying that Motorapido don't keep a stock of them.
