Separate names with a comma.
And it helps if you lightly grease the o-rings with vaseline or similar before fitting the connector. It makes them less likely to get pinched.
I should have said, to release the connectors you squeeze the plastic bits at each side to release it then pull it straight out.
Don't worry the fuel will stay in the tank apart from a few drops that will leak out when you separate the connectors. It's better to do these...
Lots of Fiats use the same ECU. MK2 Puntos and others. Have a look at a car scrappy. They might even be available as a Fiat spare.
I'm not surprised. A 900SS VIN should be something like - ZDM906SC2.******. The asterixis being the last 6 digits of the number. My previous...
Try [email protected]. I had success with this a few years ago.
Neither have I. At the last election we watched from the living room window a representative for the tory candidate stick a leaflet through our...
Better start digging that ditch then.
I too prefer the 15 for the SS. The 1200 Multi though benefited hugely from a 2 tooth increase on the rear.
The standard ratio is 15/43. 15/46 will give exactly the same ratio as 14/43. The difficulty might be in finding a 46t rear sprocket in a 520 size...
Can't help you there, only have a manual to guide me. Fuse 1 in fusebox A (nearest the top) is shown as 7.5A and supplies only the heated grips...
It is fuse 1 in fusebox A, fig. 186 in the manual. The other fusebox from the one in your pic above. [ATTACH]
On the early bikes like the 1996 748/916 the only purpose of the switch is to light the neutral light. On later bikes it would cut the engine but...
The Monster 1200 (and the Supersport 939) have a single M14 T60 torx screw clamping the eccentric hub, tightened to 40Nm. Whereas MTS1200 has 2x...
I've done both of these and agree completely. :upyeah:
It looks like a 3rd party add on for an alarm.
Personally, I'd fit LEDs. As I said at the bottom of my post above but the warning light for the indicators will cause problems since it is wired...
Open them up and solder in replacement bulbs [IMG] Or convert them to LED.
According to the wiring diagram, fuse 1 of the same fuse b(ox), marked "Optional key" is 7.5A and supplies a connector for optional heated grips....
I've had it in my Superport for 2 years with no issues.
