Separate names with a comma.
Leave that alone then. I have got the side panels off plus the long black ones each side but then I can’t get anything else off, well not without...
1200 DVT 2016 sport touring So here I am working my way around the bike bit by bit, left hand side in front of the gear change is a black square...
As long as the nuts go right over and if possible sit flush with the head then your man can get a decent weld in the centre, if you arrange for...
See if there are any mobile welders around, as stated before get three small nuts and wind them on and let him weld the centre, should come out then.
When you speak to him next chat him up and ask if he will turn my flipping service light off, damm pesky thing.
Let’s hope they build them here where they should be built.
Not sure I would want a cheap one on my nuts!!!
Service dept, not sales. Silence.
Correct the on all counts. Mine sits in a sealed plastic bag under the seat just in case I need it. I have used it a few times at home to remove...
I tried to cancel a service on my bike, two emails, one tweet and one call, silence. Oh well see if I care.
Having a new set of Angel GT2 tyres fitted to my 2016 Multistrada I emailed Pirelli and asked what pressures they recommended, they replied with...
Just been on my bike for the first time after the rear end clean and new sprockets, I went up two on the rear, now at 70mph it’s silky smooth, not...
Shell advanced 4T 15w 50 Same as dealer used and I use to top up with.
Thanks for that, makes complete sense to me now so when back from mother’s (and the oil gets delivered) I shall do the same. Brill.
Hmmm, it says you can’t remove the belly pan until the stand is off, I can, and have done many times to clean and powder coat it. But I didn’t...
I want to do an oil and filter change when I can, did I read somewhere I have to remove the centre stand? 1200 dvt 2016 sport touring. Need to...
Just done a complete hub removal and clean, worth it if your thinking of removing nuts. You need to adjust the wheel to get the chain at its...
I do still have one question, there is a hole in the swing arm where I cleaned out the crud of which there was not much, I guess the hole is to...
Looks fine to me and no idea what the hole is for.
Thanks go to the guys on this thread as I have now successfully “almost” completed the job, just need to torque the two big nuts and sprocket nut...
