Separate names with a comma.
The spring is 79911181B. No idea as to its purpose. Preventing pipe from kinking due to tight turn?
No drilling involved when removing the filler cap lock.
I see your problem. If you can forgo the immo, then tape the transponder securely in the middle of the antenna ring and the hide out of the way on...
PM me
Can you use cable ties around the ignition barrel to raise the coil.
Water ingress around the immo coil. I cured my 1198 of this by taking the ignition shroud off and raising its height by adding washers. This puts...
Eeproms can be copied and flashed but it is not something I have done. Someone posted on Multistrada.ms that they had done the US/EU switch and...
If you watch at 3:09 onwards you can see the poles go from short to long to short when attached to the base plate.
[MEDIA]
If all that is required is the lock barrel then some mole grips would snap the cam mechanism. It is only cast and probably brittle.
Here's how I did it. First job is to remove the shear bolts that hold the back plate on. They are soft metal and drill easily. Either drill the...
You may have to cut a slot in the rounded torx bolt and then use a flat blade to remove. Make sure you block off the inlets to stop filings...
I had a dirty injector on my 999. Fortunately I was able to clean it using the Redneck method. It initially was sending out a jet of fuel but...
Customs Warehouse, awaiting auction...
The fuel should be a mist not a jet
This is the barrel from a fuel cap. To remove it the silver washer has to be removed from the end of the barrel and the retaining bar (indicated)...
They are not rivets they are shear bolts. Drill a hole into them and hammer in a torx bit. They will then unscrew.
Also a TPS reset. The CO level can be set using trial and error using JPDiag. This allows you to test the effect of the CO change before...
Have you adjusted the CO level?
If you want to remove them then undo the torx and remove the retainer. You will then have to overcome the O rings holding them in place.[IMG] As...
