Separate names with a comma.
@final_edition luckily I didn't have to do this. I have IMA triples I'm putting on so I managed to sell the bottom yoke. The race was actually in...
The next bit was something of a wasted exercise but I'll post it anyway. Like a lot of dropped Ducatis, mines was no exception. The steering stop...
Now that the front end was cleared out I could work on the head stock. Removal of the head bearings is super easy. The dust seal, ball bearings...
Time for front end tear down. I put the bike on the stand as this will be it's mounting place for quite some time (since September to be exact)....
In preparation for the work to come I bought a "warrior" stand. The stand is a rip off of the Bursig stand but I picked it up for £102 after a...
So after I hear cycled the bike to set the exhaust sealant, it was time to drain the oil in preparation for what is to come. I still need to...
Diameter shaft - 20mm Diameter end - 15mm Diameter shoulder - 28mm Length shaft - 260mm Length shoulder - 5mm I think the thread pitch is 1.5mm...
@Borgo Panigale Just T-Cut and a microfibre for the carbon. I didn't even spend that long on it to be fair. 99% of the work went into the ends....
I have mine out mate, you still needing measurements?
Finally got round to finishing the exhausts. Think I'd been holding off cause I knew it was going to be a bit of a shit job. I used red permatex...
The square 4 pin connector is for the servo motor. The in line 5 pin is for the exhaust lamda sensor. Once the manifolds are replaced and the ECU...
Want to get a milled out clutch cover so selling this for some tokens toward it. This came with the bike when I bought it. On one of the spars,...
@Exige naa, these are truly disgusting. I'll do you a favour, I'll trade my new red hose for those blue ones to save you any further...
Yeah, I seen you sold them a while back but that was before I changed my mind about what colour I was going to go with, sometimes I hate myself...
I bought the DP aluminium coolant system with red hoses, however, I'm wanting blue hoses as red will not go with the rest of the bike. Looking...
Forks now sold. Thread can be closed. Thanks
This is now sold so thread can be closed. Thanks.
@final_edition some good updates to come for the bike but can't get anywhere because if COVID lol plenty of other things being done though. This...
Bought this brand new to accompany my refurbed swingarm which looked really good. I've since managed to get hold of an RS swingarm, however, this...
Refurbed this swingarm and had it installed briefly on my 1098 project but unsurprisingly, I decided to go down another route as I managed to...
