Separate names with a comma.
He purchased a kit off eBay. The original listing is long gone but this is the same one which, after a bit of research, he decided was the best on...
I'll ask my son for details about the kit he used.
You can buy kits to do passivated zinc plating yourself. My son used one when restoring his 916 Strada with excellent results.
When I got my bevel 900SS I bought an L.S. Starret 0-2.00" micrometer. It came complete with a calibration piece to check it against. It cost 30...
If you can get them I always had the best results with DCPR8EA-9 they are pre-gapped to 0.9mm.
Termi supply a sleeve thing to fit on the end of the cable where it normally attaches to the butterfly but you'd be better to fit the Healtech...
No video required. Just remove the cable, the butterfly defaults to the open position, and unplug/remove the servo motor and fit a Health ES-DO2...
Mine was made in Bologna, but those for the far eastern and some other markets are made, or possibly just assembled, in Thailand.
It's not stainless. Either an alloy or plated steel. I'd need to check and I doubt if it is easily removable. I suspect that the ball is moulded...
I've been bit unwell for the past 6 days or so, not Covid fortunately, and didn't really feel like going out to the garage. However I went out...
Yes, it's a 30 fuse mounted above the starter solenoid in front of the battery. It protects the regulator in the event of a reversed connection...
Glad to help. If you look behind the steering head at the RH side, tucked under the front of the tank you will fine a small white connector like...
I use one of these on my Supersport, replacing one of the handlebar fixing bolts. They are available in M10 but the internal hex is smaller than...
Standard ⅞" (22mm) diameter.
Instead of the copper or aluminium OEM washer fit a bonded seal washer. Two of them cost £3 and will last forever.
Ducati say that the DesertX will use the 937 liquid cooled engine. That image is of something with an air cooled Scrambler engine.
If you have an Android phone you can use Scan5MX with this cable and an ELM327 adaptor. Only cost is the hardware. As well as reseting the service...
What year/model is the Monster? Yes, the belts need to come off. It can be done with them in place but a total PIA and the job will take much...
I would suggest that a TPS reset might be worthwhile.
Cellulose thinners works a treat, or nail varnish remover. Just dampen a rag with it and rub the marks off.
