Separate names with a comma.
Well it's been a great 4 yrs on the Multi, especially once it was sorted by CJS and I had 17k miles and plenty of smiles. I'm sure I said I'd...
It's time to part with my Multi, it has under 21k miles, full service history and a few extras. It would be a shame to put it back to standard so...
Hi. Does anyone have one of these in Ducati Red they no longer want, the "handbrake" no longer uses the back seat so might as well cover it up!...
Could anyone with a paddock stand for their mutley please measure the diameter and length of the spigot that goes in the axle. I bought one from a...
Bike is now SORNED for a while, more through ill health than anything, what's the consensus regarding firing the bike up once in a while or just...
Serviced by Luigi Moto (same location as Chris CJS). Very thorough job, very knowledgable team and thoroughly recommended. Might be placebo effect...
Hi. Trying to remove my standard exhaust. All fixings undone, three nuts removed on front header but cannot move front pipe off the studs and so...
Took a dremel to the spot welds that hold the butterfly v/v on and took it out. Hope it isn't placebo effect but I'm convinced it is smoother at...
Hi. went for a spin tonight, first ride since washing the bike on Monday (no pressure wash involved, just a dribble from the hose followed by...
Hi. This is a long shot, I met a Multi rider and forum member at West Bay on Sunday (full termi fitted, sounded great!), if its you, could you...
Hi, now I'm getting to know my multi a bit better I'm getting to the point where tweaking the setup might improve the ride. To be honest I haven't...
Had a great night at Poole Quay last night, first visit, loads of bikes, great ride out. However, with it being my first venture in the dark, I...
Hi. I knocked up a piece a 16swg aluminium into a mount for my Tom Tom with a couple of folds. It fits over the spigots on Aztecs screen mounts....
Hi. Riding home last night in slow traffic the clutch lever felt very sticky, just like a badly lubed cable. Once home, engine off, operating the...
Hi. I put a deposit down on a 10 plate ABS model on Saturday leaving the final decision to Monday. Are there any points I need to get looked at...
