Separate names with a comma.
First crank done but not quite right,77mm stroke with 106mm pistons. just waiting for some oilway mods,the chap who made the crank said don't call...
I have one but it has a couple of cracks on the mount holes, nothing visible when fitted, if you are interested pm your number and I will send a...
I have two frames, one on a 748 I am breaking and one hung up in the garage with no numbers or v5, pm me for my number.
Personally I would not be worried, Ducati Quote up to 1 litre per thousand miles and whilst the mileage you quote is not high its not new either,...
I have a few gearboxes, yes post will be a pain but if you are struggling give me a PM. Oh, just to be clear, Windmills and clocks have cogs,...
IMO best way for most torque on a low revving two valve is by going big bore with a set of the original Ducati performance cams, stump pulling...
RIXSS, to nail the compression down to an exact figure you will have to measure everything and do a dummy build, this is not difficult but very...
Hello all, i am working on a project for another forum member and need to get hold of a set of rings for a 94mm bore 916, apparently none in stock...
So, you have the heads off, whats the damage? My opinion, dont blast the cases unless you want to block EVERY orifice, if you get beads in the...
That's it then, anyone know where i can get an 11 tooth front sprocket from?
Well said Mr R!
Going back to the original question i ask, why change the gearing at all? just use the lever under your left toe and just go down one or two...
Tim , i am really impressed with these pictures.
Tim, Thanks for your input, you really are in a "do you - don't you situation", Bootsam's input needs to be taken seriously as does a comment i...
Something i was fully aware of, as should the platers, Quote from them "we do thousands of these and never have a problem". As i said, my mistake...
This post starts at three different locations with three different forum members, apologies for it being posted in general but i feel this needs...
If its of any help I have some used spare std valves, if you are anywhere near nottm and need a hand let me know.
Steve, you used the right word "claimed", I am looking at a motor this week with 95mm pistals and i think the comp is much higher that "claimed"....
Forget my q on squish, i missed that but re check comp ratio. I did some working out with the calculator, if the squish is quoted at 1mm for 13:1...
Hi Darren, my sprag tooth count is slightly different at 71 tooth for a 996, the lower ratio one is also 71 tooth but does not mate with the 13...