Separate names with a comma.
Hi Paul I’ve got a primary gear puller if you want to borrow one, you’ll have to swim over to Blackpool to get it though, send me a message if...
Keep us posted on what you find with the ride and handling when you’re out on the road. Should be a great upgrade but it’s better to have...
A horrible thing that couldn’t have been given away when they were new, but strangely and deservedly desirable now. I must be getting old,
If it’s only one and price and availability isn’t an issue, apologies to everyone but it’s a Magni Australia for me [ATTACH]
Hi Gaz The easiest way is to just drain the oil into a clean container prior to removing the cover then replace it after the refit If you’re...
Hi James Changing the brushes is situ is all a bit fiddly, but there’s nothing to lose if you can’t access it as you can easily remove the...
If you’ve got a set of jump leads and any battery (car or bike) you can use them to with positive onto the starter connection and negative used as...
Not really mileage dependent, it more down to how many starts it’s been doing and if previous owners were doing lots of short runs. I replaced my...
Short answer is NO Check all connections and earth points to start with, make sure that the starter relay contractor has clean connections and...
This is my reading material for the moment,another one of Ian Falloons very good books [ATTACH]
I retired almost 4 years ago aged 65 and I honestly don’t know how I ever found the time to go to work. It takes a while to figure out that you’re...
Greetings from the posh side of the Pennines. Another option that appeals to the tight fisted (me), one that I have tried and been happy with, is...
Hi Humbug The retaining plate fits in the slot on the output shaft and rotates half a spline to allow the retaining bolts to be fitted. This will...
Stick some photos up to show the actual condition of them and also if they have the mounting brackets fitted. They are the same as the 900SS carby...
If you’re splitting the cases don’t forget to carefully check the crank oil gallery blanking plug, on mine it was loose enough to rotate with a...
Should just pry out with a suitable screwdriver, however there should be a washer and circlip fitted there, have you removed them or were they not...
Is it screwed fully home, or could there be a washer fitted stopping the switch from being mounted deep enough into the stand boss
Very nicely done, that’s a credit to you I own an earlier carbed 900 and these later ones started out as MARMITE bikes, the styling was either...
Another route to eliminating this is to add weight to the bar ends, I’ve used this method before on large capacity singles with great success. You...
