Separate names with a comma.
And with that, it was gone! Bike sold.
Provisionally sold, pending collection.
So it might be related to starting a warm-ish engine but with low ambient temperature, rather than the temp of the fuel itself. You don't say how...
OK, so I realise I might've been a touch ambitious with the original guide price on this one. So I'm going to say I'm open to sensible offers -...
So reluctantly it's time to sell my ST4s due to looking to emigrate early next year for a work opportunity - and I can't take it with me. I...
I'd be looking at one of the aftermarket aluminium clutch baskets that are available online for ~£85 or so. I fitted a K-bike one to my ST4s, and...
Bringing this one back, got out to the garage this morning and found a small puddle under the bike, that was clearly antifreeze. Got the fairings...
Bringing this one to a close, got the bike back together this morning, having made a couple of spacers for the horn bracket from a couple of...
Same measurement as my ST4s (aluminium arm). However, looking at the parts diagrams online, the ST2/3/4 (non-S) spindles have a nut on both sides,...
Finally an update! Short version, it lives!!!! For the longer, slightly boring version, read on.... Last weekend I got the engine re-installed,...
Looks like the main fuse holder. I'd try to clean the contacts with the fuse out. Also, the starter solenoid is the cylindrical silver thing with...
Does anyone know the correct location of the spacers for the horn bracket? I've got the engine back in the bike, and have 2 spacers (a thick one...
So by 0.005, you mean 0.005" or 5 thou? That's 0.127mm which may be too large to measure the clearances. On the desmoquattros, some common...
Can you hear/feel the cams binding on the shims as you try to rotate? Sorry for the silly question, but do you have the engine at TDC on the...
To cam timing, then. First off, I fitted the crank turning tool and degree wheel to the crank, and using a piston-stopper that I made from an old...
Hadn't actually thought about the throttle-body end of things. Will check that out. The inlet stub-to-head matching was surprisingly good, I was...
Does anyone have a torque value for the 3 x M5 bolts that hold the cam pulleys together? obviously there's nothing in my service manual, as my...
So, little tiny update on this, hopefully with a view to getting this finished at some point during the year...... I had decided I didn't like...
General setting to "(not) good enough" factory specs is done by the dots on standard non-adjustable pulleys. That gets us a place to start. What...
Little update, all opening valve clearances measured and shims ordered. A question for the collective hive mind - I'm using ExactFit belts and I...
