Separate names with a comma.
Clutch rebuilt. Sorted. Today was spent trying to work out why the neutral light doesn't work. I'm an electronics engineer by trade and spent...
Nope, no spring plate. No dots, all sit flat in both orientations. Where can I get one from?
Measured my steel plates, all measured 2.00 (+/- 0.02) except for one measuring 1.50, no obvious sprung plate?
That's very useful information and expands nicely on the factory manual - much appreciated! Having removed the quickshift, I have no linkage on...
I was looking at clutch kits, and a few came with 7 frictions and 2 steels? That's a great tip - thanks! After filing down the notches on the...
Just been out to check... Steel basket and steel friction plates 7 friction and 9 steels, I'm guessing this isn't standard, just an extra steel...
Also got the first MOT in ten years on this today [ATTACH] It's far nicer to ride on the road than the Ducati, that rear tyre is entertaining.
Not a steel basket, friction plates are alloy - thought most clutches were alloy/alloy but I've only experience of jap stuff? Modern tyres would...
Tyres are vintage, probably overdue a change. MOT day today, the run to the station started OK but a few miles in and I was losing clutch,...
Finally ready for MOT next Tuesday [ATTACH] I even rode it for the first time ever, amazing, beautifully smooth. Time spent setting up the...
That would explain the poor fit and construction, not sure they are BOS, there was a makers mark, no e mark though. edit: Put my specs on,...
Chopped up some expensive silencers [ATTACH] Polished the pipes and cans up, for a reputed system they are very poory fabricated
I've got the same bracket on my subframe, my cans don't have straps but an L shaped bracket on top of the can. Regardless both cans are twisted...
Synchronised the carbs today, they were out by a bit and the engine runs much smoother as a result. Hooked my guages up and propped the tank on a...
Tonights stupid question from the resident newb... My Termis are wonky, my OCD is having a proper spaz out. Both cans are rotated a few...
Slowly going through bits and pieces, removed the quickshifter and made good all the hacked into wiring, removed the headlights to inspect the...
I'm having exactly this issue, the scabby frame is staring me in the face, I promised her that it wasn't 'another project', I could touch it up,...
Absolutely blinding! Thank you
Brilliant thanks very much, I can see what other things are wrong as well now, starter solenoid wrong way round for a start... Regarding the...
Third reg/rectifier unit turned up and it works fine. Wires don't reach though (yes they are correct length), should they pass up behind the...
