Separate names with a comma.
Hello all, On previous bikes I have dropped forks a little to improve turn in. I have seen some posts on net to suggest I can increase rear ride...
Hello there, Last year I done the same. I think std chain is 525 pitch. Not sure on length as got dealer to change. I went with a DID chain and R...
That's my mind at rest now. Thanks to all who replied!
Thanks for the comments all. Makes me worry less
Checked my oil level and it was slightly above top line (max). Have taken about 200ml I think and it's now on max. See what it's like next time I...
hello all, Had my 1199 1.5 years now. Bought with 5k now got 7k on it. Never noticed smoke after start up but had in for service last November...
hello all thanks for reply. I removed slave cylinder to find it looked fairly clean. Rinsed piston with wd40 then applied high temp grease to...
Hello all, Does anyone know torque spec of bolts when refitting slave. Is thread lock required?
thanks for the instructions bootsam. I will take off OEM slave and look if I can clean up and if no improvement then try an aftermarket one as you...
So what's the procedure to remove. Do I remove slave and just pull out rod or will something fall off? Is it a good idea to scotchbrite then...
can I remove slave without draining fluid to have a look?
Hello all. had a quick ride out today. Not really been on bike since serviced in November. I was reminded of clutch feelings notchy as engine...
if I take off cans will do threadlock and lockwire. thanks for the advise all.
How do I lock wire the bolts?
If / when I have to do it am I best replacing all bolts. Should I use any special washers or thread lock so I don't have to do it again. Also...
not keen on that. Think I will leave it to rattle
Will have a look thanks for above
Hello all, Any recommendations on how to tighten the 4 bolts keeping aluminium sleeves onto std cans?? Can it be done without exhaust removal as...