Separate names with a comma.
UPDATE - error checked during recent service and the fault was a MAP sensor, which the dealer had in stock and replaced so now all ok. Hope this...
Thanks again for reply. It is expensive to buy the OBD cable and software? She is due new belts so I could get the dealer to check when I take...
Thanks Ackers. Its a Pikes Peak with a full Termi exhaust so will this have an exhaust valve?
Started the bike yesterday and Errors Engine appears on the display. The bike started ok and seems to run ok but I have not taken her for a spin...
Hi, just seen this thread while searching as I have just had exactly the same errors engine problem on my 2014 1200 Multi. The bike started ok and...
Just checked back to see what I had bought. I bought a pair of Nightrider indicators and and also a separate pair of Oxford 9 watt resistors. The...
Yes I did use resistors. Ironically, I bought some different resistors than the ones that came with the first indicators that I tried, just in...
Hi, yes I should have posted an update. I went back to basics and checked the rear wiring loom and found a fault in an original Ducati connector...
Thanks Ackers, it seems I am on the right lines then. Seems to be no leaks so hopefully the Threebond is a bit OTT.
Oh well - a bit disappointed that I have no replies - so I have done it anyway using the torque setting that I think are correct and without the...
Quick advice please: What are the torque settings for the drain plug and oil filter - just checking? I have found: Drain Plug - 20 Nm - very small...
Hi Nelly - Success!! I took off the rear sub loom and checked it over, all fine. Then checked each indicator, again all fine. But then I added the...
Thanks Nelly, understood. Will let you know once I have done this.
Thanks Nelly, I will do as you say. How do I check the insulation from other cables?
This is the end part of the loom before it connects to the tail tidy wiring. This photo came from ebay but I have shown where the common earth...
Hi Nelly, thanks for your reply. Yes the front indicators work fine. I did a check on the common earth - 3 wires come from one under the tail tidy...
Thanks Derek, yes I agree. How can I find out whether either are at fault?
Thanks Chris, yes could be all those! I hope Nelly can help!
The lens casing says 10w so must be different to some others.
Brilliant, thank you, hope he can help.