For Sale 48 Tooth Slipper Clutch Inc Plates For Sale

Discussion in 'Parts, Accessories & Clothing For Sale' started by dingle, Jun 17, 2016.

Thread Status:
Not open for further replies.
  1. Quality TSS 48 tooth slipper clutch, complete with a full set of drive and friction plates.

    These are fantastic clutches - same as EVR / Yoyodyne and retail at around £800 without clutch plates.

    The 48 tooth units are quieter, more reliable and are subject to a lot less wear due to the drive load being distributed more evenly.

    The clutch is in very good condition and has little wear.

    The clutch plates are used but with plenty of life left in them.

    Complete unit inc top-hat spacer, washer, seal, spider spring, ball bearings, clutch springs etc.

    Will fit all dry clutch Ducati's, if fitting to 1098/1198 I believe you will need to purchase a larger clutch nut

    Was intending to fit to dry clutch model but recent upgrade to a Panigale means this is now surplus to requirements.

    £390 delivered to UK

    IMG_4875.JPG

    IMG_4966.JPG

    IMG_4967.JPG

    IMG_4968.JPG
     
  2. May be interested in this. What's the stack height of the plates please?
    I think that TSS make a couple of versions, one for earlier stuff (900ss etc) and one for later (Hypermotard etc.) I'm guessing that differences would be minimal but it would be useful to know which bike it came off?
     
  3. Hi mate, am no expert so have taken a pic and attached. From the first (engine-side) plate to the red pressure plate it is 38.16mm.
    Am sure if I have measured incorrectly someone will post and put me right?
    I have emailed the guy I purchased from but he has not got back to me, I am pretty sure it was from a 749 but don't quote me on that.
    Cheers

    IMG_5030.JPG
     
  4. Just to confirm, this was previously fitted to a 999S
     
  5. Sold, thread can be closed. Cheers
     
  6. Thread closed
     
Thread Status:
Not open for further replies.
Do Not Sell My Personal Information