1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

1299 Warmers

Discussion in 'Panigale' started by Noste500, May 7, 2021.

  1. Looking at the front mudguard on 1299 and it looks pretty tight with a tyre warmer on the tyre . ( carbon mudguard ) anyone running warmers and find it’s tight against mudguard ?
     
    #1 Noste500, May 7, 2021
  2. They are all tight to the mudguard, just the way it is ....
     
    #2 Dibble, May 7, 2021
    • Agree Agree x 3
  3. I guess some will be thicker than others.
    Capit fit no problem.
     
    #3 990Glen, May 7, 2021
    • Agree Agree x 2
  4. No problems with Diamond tyre warmers.
     
    #4 zxstu, May 7, 2021
  5. My diamond is really close ( basically touching )
     
    #5 Noste500, May 7, 2021
  6. They are snug but 3 years of use found no issue - look on the bright side less heat loss.
     
    #6 zxstu, May 7, 2021
    • Like Like x 1
  7. Make sure it’s stretched as you fit so it doesn’t bunch up helps
     
    #7 bradders, May 7, 2021
    • Agree Agree x 1
  8. It does look tight but you’ll be fine. As bradders says, feed it in with a bit of tension keeping it nice and snug :upyeah:
     
    #8 Mary Hinge, May 7, 2021
  9. Tip I picked up from spike edwards video : roll it up as you take it off, put the Velcro by the valve then as you put it back on it’s easier to stretch. When you take them off, it’s also far nearer than just slinging them across the pit floor ;)
     
    #9 bradders, May 7, 2021
    • Like Like x 1
  10. Cheers , I’ve tracked about 15 bikes and not had the mudguard so close to the warmer . good to know all the same .
     
    #10 Noste500, May 8, 2021
(You must log in or sign up to post here.)
Do Not Sell My Personal Information