Separate names with a comma.
I didn’t realize there was a video. Phill sound correct… that doesn’t look like a head gasket from the video. Are the manifold nuts tight ?
Most of the time a gasket gets compromised from engine overheating. Sometimes the compromise can cause the pressurised combustion to find a way...
Usually by the time it gets to where flames are blowing out of the gasket, the gasket is severely compromised. I would be really concerned for...
I just put Evotech levers on my wife’s 636. I used a small socket that just fit the sleeve diameter and lightly tapped it out. I hope that helps
Thanks Chris, until a few minutes ago, I thought Android was a cell phone and not an OS... I just ordered a Galaxy tablet that was listed on the...
Hi, I am heading out on a 1,200mi trip in 4 weeks and would like to have my ECU remapped/flashed before I go. Unfortunately this rules out a JHS...
Good point, thanks. I'm mostly satisfied that my new compression gauge is very inaccurate. Next time I pull the tank I will check with a different...
Looks great!
I would think valve clearances would cause a loss of compression and sticking/bent valves cause high compression but I could be wrong. I did find...
Thanks Derek, I am thinking the gauge is way off. The shop manual quotes 210psi. Thanks!
I would appreciate any thoughts on this... 2012 848evo, 3,000mi running rough abouve 95c. Compression test , engine warm, Vertical - 245psi...
My spring is from a 2012 848 Evo that had 8,000 miles. Length 500.128mm Outer Dia 20.018mm Inner Dia 15.025mm Spring Dia 2.678mm I hope this helps.
I have a spare wet clutch spring from an 848 I can measure if that helps?
