Separate names with a comma.
Just to update. Read some posts on an Aprilia forum that spoke about tightening the spinning 8mm allen bolt which screws into the bottom of the...
I've used him too mate; zips, ring pulls, knee n elbow patches, rips. Cracking job. Nice guy.
Thx folks. Think I'll stay well away from taking the foot off the fork tube ! Knew it was a bad idea. The risk of fecking things up is too much....
Thx Ricky. It does certainly look like that on the diagram. Thx. I can't get the bugger undone. Damper rod captive and still, Allen bolt just...
Hi folks. Currently servicing MTS 1260S forks and wishing to dismantle the damper from the slider tubes. There's a very small grub screw (which...
Good to hear the camera support was forthcoming without pain and grief. I too have the VanTrue F1 and it's been remarkably very good.
It can't go anywhere except stay in the gap. There's no other space for it to move into. Fitted and working for over two years and regularly checked.
Short Peice of cable tie does the job.
Either go 14T front & 40T rear or 15T front & 42T rear. There are those who think keeping 15 front gives the chain an easier life.
Hi mate. I changed to my '18 1260S from my '16 1200S in Feb this year. I immediately noticed the improvement with the dash layout and much more...
Hi there. I'm no expert but I'd say as the belt tension changes with the change in revs then you're bound to see the amplitude of the belt...
Thx Ed. I can recall you mentioning that elsewhere. Thx mate.
Hi Ed. Any update on the issue and its resolution please ? Thanks. Rich B.
Hi Mark. For a fiver, I've just fitted these Chevron cricket bat grips over the existing worn Ducati heated grips on my 1260. Fit is spot on....
