Separate names with a comma.
I wasn't asking what bikes different people find attractive. As it's only 2022 it's 12 year old, and it is the S. I was just wondering if anyone...
Hiya peeps, due to a knackered right hip (68 years old) I've decided to put my 2010 Multi 1100 up for very reluctant sale. Problem is I have no...
Hi Ben sorry for the late reply. I had the ECU tested by Avanti, no fault found. On fitting the new starter motor the thing fired up and has run...
Many thanks for the replies. The bike doesn't do a lot of miles so the price of Super is not an issue, as long as it is available. Over winter I...
Hi all, now that the dreaded E10 has been forced upon us, what can I do to prevent any problems with fuel lines etc? Running on Shell/ Esso E5 at...
Hi Alex, I hope your repair lasts longer than mine did (1 week). Good luck mate.
UPDATE: Tried a simulated bump start, ie 6TH gear, ignition on, plugs out, sidestand up, spin the back wheel, no sparks but a wizz-...
#18 should read MENDERS not lenders
Can anyone (trade or otherwise) test out my ECU. I can post or drop it off if local. Chorley, Lancs.
Doubt it Old Rider, the engine wouldn't crank if it was stand or clutch and yes, the pump primes at switch on. Many thanks.
Thanks Derek, I tried cranking the engine and the reading was just under 1 volt ac. Looks like the CPS is good, I'm running out of ideas now....
OK, just tested the supply lead to the CPS. One is a good earth, the other 2 read 2.5vdc and 1.6vdc to earth with the ignition switched on and the...
Hi all, just disconnected the CPS from the 3 pin plug. Across 2 of the pins there's a resistance of a steady 880 ohms, spin the back wheel in 6th...
