chrisw's Recent Activity
-
chrisw replied to the thread Degrading Adverts.
What surprises me is the number of female celebs that are so skint they are having to sell their second hand clothing on eBay.
Dec 5, 2025 at 1:28 PM -
chrisw attached a file to the thread Hyper 821 Immobilizer Error.
@nelly will confirm this, looking at the programming procedure it looks DIY providing you have the PIN code for your bike. The...
Dec 5, 2025 at 1:26 PM -
chrisw replied to the thread Hyper 821 Immobilizer Error.
On some bikes this can be caused by water blocking the signal from the key transponder to the immo antenna. Usually caused by a down...
Dec 4, 2025 at 7:09 PM -
chrisw liked nelly's post in the thread 899 Radiator Reflector Conundrum.
Looks like are you missing or have removed the plastic "plate" that screws under the bottom yoke? It's that that should push the flaps...
Dec 2, 2025 at 12:14 PM -
chrisw replied to the thread 996 Tacho Not Working.
I suspect the latter
Dec 1, 2025 at 8:35 PM -
chrisw replied to the thread 1200 Melcodiag Problems.
Looks like good support
Dec 1, 2025 at 7:02 PM -
chrisw replied to the thread Dodgy 999 Shallow Sump Engine.
Walk away. It is either nicked or from an insurance write off not allowed back on the road. That stamping will always cause you...
Dec 1, 2025 at 5:37 PM -
chrisw replied to the thread Scots And Gaelic Now Recognised As Official Languages.
What do they speak around Cameron Barracks?
Dec 1, 2025 at 5:32 PM -
chrisw replied to the thread 1200 Melcodiag Problems.
Have you watched the video? They could not get it to work. It is possible it may work with bikes using the IAW5* family ECU but not the...
Dec 1, 2025 at 5:27 PM -
chrisw replied to the thread 1200 Melcodiag Problems.
Download the MultiToolDecaf program. Read the manual. It will work with both USB and BT ELM 327. [MEDIA]
Dec 1, 2025 at 4:26 PM -
chrisw replied to the thread 899 Radiator Reflector Conundrum.
What side of the bike is that when sat on? Left or Right? The part in the picture is marked R = right?
Dec 1, 2025 at 3:54 PM -
chrisw attached a file to the thread 996 Tacho Not Working.
I have built a prototype buffer device. It is built around a 2N7000 mosfet and two 1 kΩ resistors. The wire into pin 24 on the ECU will...
Dec 1, 2025 at 1:32 PM
-
chrisw replied to the thread 996 Tacho Not Working.
Just re-read the thread. As the output on pin 24 falls 0-12v then it is not open collector. So a pull-up resistor alone will not work....
Nov 30, 2025 at 9:26 PM -
chrisw liked Chris's post in the thread 996 Tacho Not Working.
I really hope that you don't give up, look at this as getting closer and closer rather than getting further away. Between all of us,...
Nov 30, 2025 at 7:26 PM -
chrisw replied to the thread 996 Tacho Not Working.
Pins 26 and 35 will give a 12v supply to link into. Pin 26 is linked to the ignition switch and 35 to the main relay. A pull up...
Nov 30, 2025 at 7:13 PM