Separate names with a comma.
Done some work then some weights lol :)[IMG] [ATTACH]
Lmao
The smaller 1098 pin will fit a diavel :)
As above also disconnect the the electrical plug from the pressure switch put this too earth with a piece of wire etc with the ignition on just...
Possibly spanner check the bike make sure everything as it should be as it seems to be a uncommon issue
The 848 swing arm isn't shimmed like ss etc as the engine cases do not support the bearing for the swing arm pin I think will be more likely as...
Lol as much as id like too say yes !! Take the old girl for a run and stretch her legs down here
Should do pretty sure the pump is the same
Side stand switch ? Feed relay ? was the dash etc still operational when it cut out
Thanks guys and girls :)
Ah I see are you still having problems with it selecting neutral ? Is it fine when u actually ride it ? No clutch slips etc ? Cheers wayne
This spacer is for per 2000 model year ducatis with a shorter pushrod 916etc and should only be fitted if the pushrods protrudes less the 30mm...
Hi are the clutch springs going coil bound ?Also the spacer you got with your slave cylinder for the push rod should not be fitted . As Your bike...
Would just like too say hi from the midlands I don't actually own a ducati at the minute as i sold my 749s but i am an enthusiast and work on...
