Separate names with a comma.
Spacer/ pin is £16.80 from MotoRapido inc VAT Bearing £8.64 Seal £3.66
999 I have in for service (2003, 5000 dry miles- very little grease in there!) needs a new rocker pin and bearings. I'm thinking of fitting a...
Yes that's correct, back 90deg for the vertical, the T marks in the cam pulleys face down towards the cranks, where as the H cyl they are up side...
just watched the videos, it's all come flooding back to me now. Thanks for all your help folks!
thanks guys. I did the belts on a 999 before but this bike just strikes me as wrong. As i recall when the drive pulley mark is aligned the cam...
need to do a belt service on a 2003 999 tried Carlslater.com but the 999RS04 manual is missing the belt pages (160 -170 ish) any help appreicated!
rust free as possible. possibly the 600SS fits too for mid 90's carb model please
condensation is an issue on my 900SL, and of course that's oil cooled, so it's not the head gasket or water leak. It just needs a good run to get...
probably keep hold of the rear shock GDS968 as I believe it will fit my earlier SS carb model. Had a fair few messages about it but as yet...
the guy has spent a lot of time masking the lines in the paint it. yet didn't make any effort to rub down the scrapes or fill them and then...
it's pretty shocking how something can be serviced by a main dealer yet be totally abandoned by an owner. don't think it had been cleaned in months!
indeed!
