Separate names with a comma.
Was there a solution to this problem? The chamber at the bottom of the cartridge to allow for expansion leaks the gas. This enters the fork and...
Any further developments with this? It appears to be keeping rythm with the cambelt rather than engine revolutions P
fixed sensor. Solder and insulation and everything is now perfect. The broken wire was 15mm shorter than the rest of the loom and broke due to...
extended/ topped out after going over a ramp. I was unaware of this all pointing to this gas leak into the fork. I checked the travel when I...
had the effect of increaseing preload and the front end riding high. I didn't know this and found the headlight aim too high, so I adjusted it...
Hi Rob, only seen this now. It appears there is a recognised issue with the 13 & 14's. Apparently the fork was made in a similar way to a rear...
Mine's a '13 with 43k km. Fuel level sensor, it's on the 3rd. Left Skyhook fork leg's been replaced at my expense. 13's & 14's had issues with Gas...
If I understand correctly this is not a preload issue but the suspension is topping out. Is the bike leaning too far on prop stand? Apparently the...
Yes, the original Ducati leads were cut and soldered to Daytona wires. Polarity no relevant, just connect them. I insulated with Heatshrink. I...
Yes. Mine failed so I fitted Daytona grips to the original wiring. They suit me better as I found the originals too short, i.e. not wide enough,...
Hi folks. Just a word of warning to all when re-assembling following valve inspection. Ensure you use the correct screws to refit the V-piece...
I'd check your charging system. Tacho only works above a certain Voltage threshold. If you have charging problems it will give the results you...
I can see how difficult it would be to change aircraft oil when the engines are hot. "Lets bring this for a spin round the block to warm it up"!!...
Yeah, I find it necessary to keep an eye on the wheel bearing as there are no dust seals protecting these bearings. New bearings every second tyre...
