Separate names with a comma.
Feeling, er, lonely yesterday @Exige ?
Ok, let's resurrect this thread when the clocks go forward and riding bikes for a laugh in Scotland starts to feel feasible again.... Mick..
We're looking dangerously like volunteers here, Desmo.... How about around early spring we agree* a date/time/place for a meet in the Summer and...
Good idea Desmo. What about something at Hartside or St. Mary's loch? Hartside's accessible for more folk, obviously.. With any luck my 750 will...
I power washed mine after soda blasting. Should have seen the state of the yard!!! Once it was dry, an air line to blow any remainig soda away -...
I couldn't get into mine at all. I've done it on a Honda VTR before using translucent fluro paint meant for an RC car. That works well over...
So I performed nipple surgery today.. [ATTACH] Genuine, new Brembo bleed screw on the left, stainless aftermarket one (pretty sure from Hel) on...
Haha - blind leading the blind, this... I soda blasted the engine first - pics and a few words somewhere above in this thread. Then I used...
Got mine through local ducati service centre. Apparently bleed nipples are classed as a service item and not subject to the same nonsense as...
I've had the same thing on my '94 750SS. I rebuilt the calipers completely and replaced the original knackered nipples with stainless ones from...
I know the feeling.... The bikes all look good in the article. Lumbux's and the 900 above it ate the smarter of the 4 IMHO. Well timed article...
You had to bloody remind me about that, eh....?!:Banhappy:
Yep, a bit off either end should do
I just did, man. Pay attention....;) Mick..
Not as massive as you'd like it to be..? Mick..
M4, 8mm overall length, 6mm excluding the cone. Take a 2mm hex key. Make sure the ones you get have a deep recess for the key too. Ey thengyaw...
I've just put the effers back but give me a minute and I'll take one out (if it snaps/rounds/falls in the tank mind, you're for it....) Mick..
Come on, ya pansy! :upyeah: [ATTACH] MICK..
Yes, I think some off either end is the starting point. I have less clearance than that to my swinging arm AL. At least without endless fiddling...
I reckon I could get about 2" - maybe a tad more - off the end of the link pipe and the equivalent movement forwards of the can. It'll stick out a...
