Separate names with a comma.
High all. I've fitted new map sensors, a rear accelerometer sensor, and a new fuel level sensor in the tank. Before all this did a complete...
Well, for anyone that has seen my earlier posts, i have managed to fix the rough running on my 1200S Touring. Relaced the front HT lead and all...
Hi all. Does anyone know how to do this? I have a Rolson multimeter and I need to check if the sensor is working as I have a DSS error which...
Hi all. Does anyone know of any diagnostic technicians (not main dealers). I live in Leicestershire but willing to travel. There was one in...
Thanks very much for the replies all. I would really like to find someone locally who knows how they should be to take it out and tell me if they...
Hi folks. I have never owned or ridden a twin cylinder 4 stroke motorcycle before the Multistrada. Mine now seems to be running ok, ie not...
Update: O2 sensor connectors- addaed some dialectic grease, and to the MAP sensor connectors. Took her out for a 50 mile ride and didn’t stall...
When fitting the new MAP sensors, does the engine have to run through so many cycles before they start to work? I've fitted 2 new ones and, as...
Thanks for the advice Neo. I’ve been away since you posted so apologies for not replying sooner. I haven’t done that yet. Just before I left, I...
Thanks Siddo. I get back home tomorrow so will fit it then - Fingers crossed.
Thanks very much for that. Sent the others back and followed your link so, fingers crossed, that should do it. Funny but I spoke to someone in a...
I have a few issues with the MST, one being a faulty Lambda sensor. A friend with a Tiger advised me to get an eliminator kit which will both get...
Well, nose cone sensor plugged in. Unplug it I get an EML. tested the vertical map sensor (pig to get at!) with the old sensor that I thought was...
The MAP sensors I got from Amazon were quite cheap non OEN. £58 for 2 sensors. I’m sure you know that they are quite a bit more than that normally...
ir Thanks Derek. I was under the impression that the servo eliminator, if not plugged in, would make the bike run roughly but I have taken the...
Finally got Melcodiag working. Several errors about the exhaust valve being disconnected - P1009 Status 28, P1007 status 68, P100B status 28,...
Hi all. I have MTS 1200S 2013MY running rough when warm. I've downloaded Melcodiag and obtained the licence. I purchased 2 new MAP sensors and...
Too late for that. I've drilled the flap off and cut the cable so the eliminator is the only way!
Hi all. I’m having a few running issues with the MST. It’s a 1200S Touring 2013. I took the exhaust flap off, an cut the cable, intending to...
Thanks a lot tzoykas. Really helpful. I’m tempted just to replace them both as I’ve had enough of it now!
