Separate names with a comma.
Nowadays, she's always waiting for me. It's 2.24 am and I'm going for a ride. Not much traffic, you see. My 600ss is spinning oh so...
Question as per title.....Because before I start heating and bashing to separate mine, I think I may have one! And, if so, what do I do to join...
Can you tell me how your cush drive to sprocket carrier is set? I'm replacing the cush drive pins and rubbers on my '97 supersport, I put the new...
Folk, please help with a pointer or two: I have just sorted my ignition with new pickup coils and was thrilled, but all of a sudden I ran into...
Dear Folk, Could you help me in my interpretation of a recurring symptom and my electrical tests, please? I wonder, Should I immediately replace...
Looking hard at the RH throttle control, which contains the balance screw, and actuating levers both left and right carbs, I am puzzled by the gap...
Hello folk, I'm considering wether to put hylomar on the gasket surface of the barrel gasket (only) - do you consider this is a good idea? The...
Need a piston in good condition for 600cc ss motor, and matching pin possibly. I hear pre-'98 forged pistons were replaced with cast on later...
Regarding the characteristic metallic noise from the front cylinder, said to be 'normal' piston slap, and a sound to tolerate, I still wonder...
Attempting to remove my oil strainer for inspection, I found it didn't come out with the bolt, and I have been unable too withdraw it by...
Advice on fitting a new lock, offer of spare, appreciated. It's my 1997 600ss. As Per title, yesterday at night outside house for a few hours...
Hi Folk, a quickie: I know the fuel pump keeps on pumping after priming on pre-1997 SS, but does the Mikuni carb set up with the SS tank draw...
I would like to know the correct form of a Vin Number for a 1997 Ducati. It is written on the frame as follows: ZDM600*XXXXXX* - (where...
Could you give me your experience or sightings, if any of this kind of mod - I mean where you find it sensible to mount a particular kind of...
I have taco drive boss (ducati 600ss '97) to remove from engine in order to clean the tacho cable retaining thread of superglue. Having removed...
Attempting to synchronise carbs on bike running on side stand, a Ducati 600ss; I find it difficult to see the carb sync acres and so get a...
I've checked my rocker gaps on a takeover ducati 600ss. All good except that I am puzzled by one observation on my present setup. Given that the...
Got round to dismantling forks on new bike takeover. The left hand slider is worn with a noticeable flat (it must now be quite thin); it appears...
Hi Folk, Concerning my takeover of a 600ss: I've dismantled to clean tank and carbs etc..... I've come to put the battery in and route the...
