Separate names with a comma.
Take it they are only used one time? Almost certain I have the pliers to close them, if it’s the same as my Agusta use
Question on fitting these, do I need new fuel lines as I am reading that they are special types of hoses or something? or alternative clips ok?
Oh yeh there are these https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F333178511478
Yeh but he couldn’t remember where he got em from last time I asked
Looking to swap out my plastic ones which look way past their best. Can anyone tell me where to source theM from please? I remember something...
My floor got a lot dirtier!
Before and after shot! [ATTACH]
Sorted! was exactly that, spoke to Rich at Louigi and he suggested that there are times when the tolerances are just a touch out. [ATTACH] [ATTACH]
The plating has been finished off properly on this, but I did notice late last night a small burr on the splines which is where it’s picking up -...
They are replated, but in honesty they are some of the best plating I’ve seen. So close to original
Da daaaa [ATTACH] [ATTACH] [ATTACH]
Thought that but there is nothing inside that I can see..
Ps ignore that lump hammer that categorically was not used in the tapping of any axle pins :joy::laughing:
No mate it’s getting stuck on a part that’s not coated.. it’s weird!
Tested it from both sides and it gets stuck at the same place. No spacers have dropped here is is tried from both sides [ATTACH] [ATTACH]...
Had an exchange axle pin but really struggle to get it in to the bearings on the left side. Tried tapping with a rubber mallet to persuade it, but...
looks like a great project bike that does! keep the installments coming!
Yeh that’s today’s job!
And it washes off with water?
Paraffin safe on painted swing arm?
