Separate names with a comma.
That is one mother of a gaping hole in the swingarm. Looks a lot bigger than the road going 2025 V4/V4S. Oh and look at how far the forks are...
My wife's 620ie is still going strong after 22 years of ownership. I do find it a lot more manageable in terms of weight compared to my own bike,...
:D That reminded me of a trip down to Italy, when I was living there, with my wife on the back of my 999S. Fuel stops were not so much dictated by...
Yep. Just waiting for my overtime cheque to kick in to pull the trigger. Sadly funds for the bike have been depleted recently with my eldest...
To be honest for the equivalent of an overpriced latte at Starbucks, the subs fee is very reasonable and helps support this community. You could...
As mentioned in my feature thread I've decided to go for the "Duessen Engines" ECU map, largely because of his reputation and the ease with which...
No, roads were dry as a bone. 'C'est la vie' I think in my case.
If it is the cam type lock barrel, you can remove the screw and belville washer and position the operating lever one notch further away to...
You should count yourself lucky using the Connect app. I am running the Ducati Link app, which is even flakier. Ducati in their wisdom, decided to...
Cut the grass and edged the lawn. Curiously satisfying knowing it will stay looking like that for a few days before it needs tending to again....
Once navigated all the way around southern spain on my 748. Planned a route on my ordance survey map each night before, then cross checked the...
Dayuum! As you well know suffered the same fate as you recently, albeit on a 600 mile old tyre and was only a small pin tack, but did enough...
No in the case of my Termi exhaust, there was no foil lining attached. I would personally apply any additional foil over the top ensuring you...
This should fit either a V4 or V2 (V4 2018-2024) and V2 (2020-2024). I believe you would need some sort of a threaded adaptor to run the stock...
That's the issue I have, removing the sticker without damaging it, to expose the roll pins/s and thereby remove the key's blade to replace it with...
Lovely bike Ian, as have been all your previous steeds, especially the CCM.
OK so some progress. After searching for over 24 hours, I finally found my other set of keys. They were languishing in another jacket, that I...
So a bit of a disaster today. Set off for a ride-out with my missus, stopping at a petrol station a few hundred yards from the house, then...
You could always approach a reputable bodyshop. They would likely tack weld a pin to the area and use a hydraulic tool to then pull it out. The...
Good luck. Might be worth fashioning some sort of a jury rig for the drill to ensure you go in at a constant and correct angle. Doing it by eye...
