Separate names with a comma.
Thanks for the heads-up, will get the acf50 all over.
Washed all the salt & winter crud off the poor XBR500 winter workhorse, came up ok, was relieved & felt guilty for putting her through it... Hyper...
Just need to fine tune the baffles to get the mellow deep sound without breaking the neighbor's windows...
Had a leak on mine recently, sanded the face & found the brass inserts & surrounding areas were proud, doing this & replacing the o ring solved...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] Termis on.. Started with baffles in, each baffle has the end blocked & 3 x 8mm slots in each... too quiet,...
I had mine mapped by CJS a few years back but will need a remap for the changes to intake & exhaust this time so plan to go to BSD in peterborough...
That was a result. Did the cams get dialled in, this makes a big difference to rideability I found when I first did this. I like the look of the...
Will post piccie before & after with weight savings Glad you could replace the foam, where did u get it? The MWR setup is pretty good & you will...
Finally conceded that I needed termi 2 into 2 for my evo to replace std cans after 8 years... Recently swapped MWR airbox lid for ram stacks & pod...
Are these sold, if not I'll take them. Chris
If they put them 6" higher it would look right plus you would get some wind protection
Is it just me... looks like they put high bars on a sports bike. Headlight is 6 inches too low.
I have one loose in my parts bin & probably have others on carb sets, do you need just one? If so can post to you. If you need 2 will have to dig...
Started benelli 2c, hadn't run for a year, year old fuel in tank and carbs, didn't drain or anything, would you believe it started 3rd kick....
Neeps I'll have it.
Is it an aftermarket slave? Some of these require a spacer inserting into the small bore of the piston, if this is missing lever would be solid.
I had tidy up today & have the following 7mm shims that are now obsolete for my hyper. Ideally would like to sell as a job lot, 13 items, though...
Hang in there pal, its gonna be a transformed beast, you will soon find the love...
Re gearing, if its custom mapped properly then you only need to go up 1 tooth on the rear IMHO. Mine pulls clean from 30 in 4th about 2250, im not...
I got a syringe to fine tune but just used a 300mm rule for initial measure.
